The Iemca Boss 21 is the ideal bar feeder in the presence of limited lathe spindle length or when available floor space is restricted. The full range of Iemca Barfeeders are also available.
Pricing dependent on exact specification and requirements. Please contact us on 0800 783 0510 or email firstname.lastname@example.org
Model Boss 21 is a compact feeder for bar diameters from 5 to 51mm with max length of 2080mm.
This is the ideal bar feeder in the presence of limited lathe spindle length or when available floor space is restricted.
Boss 21 can work with bar lengths of up to 2080mm, thereby eliminating the need to section long bars into 3 or 4 pieces and reducing the quantity of unusable remnants.
This bar feeder, which can be used with both fixed and sliding headstock lathes irrespective of the lathe spindle length, features very compact dimensions and offers the major advantage of remnant recovery; material is supported with fully enclosed guide channels with hydrodynamic support as on the standard Boss barfeed models, designed for long bars.
Simple to Use
The Iemca barfeed devices design allows for simple set-up for both mechanical and component programming. Iemca devices allow for setting-up a new material size on full length barfeed models to be both quick and easy and can be less than 2 minutes.
This is the ideal barfeed when lack of floor space is available. This compact model is ideal for automatic loading of longer lengths of material when spindle length is limited.
The compact and intelligent Boss 21 is capable of feeding bars at maximum speed without having to adapt bar length to the length of the lathe spindle. This greatly reduces the number of wasted remnants.
The Boss 21 offers the major advantage of remnant retract for material shorter than 2M. This feature is especially important when machining large material and reduces the possibility of any internal damage to the lathe when ejecting a remnant through the front of the chuck into the lathe.
Bar Clamping Device
Bar introduction/extraction clamps self-centring directly on bar, requiring no adjustment by the operator when changing bar size.
The round section guide channels are fully closed and lubricated and can be completed replaced without tools in less than a few minutes.
Front Bushing Device
The front bushing holder device allows a fast change of the front half-bushings at every working change (less than 30 sec).
An extra front support bushing device gives additional guidance and stability to the bar feed for bars that are smaller than the spindle bore.
Axial Shift Device
An axial shift device is offered for access to the rear of the lathe
Changeover from one material size to another is made simple by the Iemca design features. Changeover times can be as low as a few minutes.
Unless otherwise stated delivery will be made via TNT: