Tecnomagnete Radial Pole guarantees the highest quality standards in turning and vertical grinding.
Constant quality of the workpiece
In all manufacturing processes involving wheel turning, bearings, rings and flanges, a common problem is how to clamp the workpiece without deforming it. The traditional mechanical clamping tools can cause ‘ovalization’ and the deformation of the piece.
Radial Pole clamps the piece from its base surface. There are no obstacles to the tool path; the complete machining operation can be made in a single setup.
Using the pole extensions allows you to raise the piece from the magnet surface, making both inner and outer diameters fully machinable.
The uniformity of clamping, a typical characteristic of the magnetic system, removes vibrations with consequently enormous advantages in terms of machining tolerances, tool life, chip removal and machine productivity.
The new PRF series in monolithic technology is equipped with a totally metallic surface; this guarantees a great robustness and a perfect isolation of the components located within the system.
The rectangular pole offers, compared to alternative trapezoidal-pole solutions, consistent performance along the radius (then on pieces independently from the diameter) and constant depth of the magnetic flux.
Automatic shimming and stress release
The combination of mobile and fixed pole extensions creates a flexible bed which adapts the magnetic surface to the workpiece, compensating for the irregularities without the need for shimming.
The stress release operations are performed quickly and automatically.
Full use of the machine table
Radial Pole allows a full utilization of the machine table, as it does not require space to be allocated like traditional clamps.
Radial Pole can be installed with a diameter equal to or even slightly higher than the machine one.
Concentrated force without magnetic residual
The “Neutral Crown” configuration allows full concentration on the magnetic flux on the active surface only, guaranteeing the maximum efficiency and the total insulation of the module.
The “PRF” models are equipped with a control unit which has a special cycle of demagnetization (Nuflux system) able to completely remove the magnetic field from the workpiece during the DEMAG phase.
|Model||External Diameter (mm)||Internal Diameter (mm)||Height (mm)||Weight (kg)||No. of Poles|
Unless otherwise stated delivery will be made via TNT: